with the “-M44” option. The volume control for these speakers is located on the inter-
com. Model ADSS-25-Z has a swivel-mounting bracket, while Model ADSF-25-Z has
holes in its outer flange for flush mounting. All speakers are rated for 25 watts.
SpeakerSpecications ADSV-25-Z ADSS-25-Z ADSF-25-Z
Frequency Response (Hz) 800 – 5,000 800 – 5,000 800 – 5,000
Power Handling (Watts) 25 25 25
Shipping Weight (lb.) 10.0 6.0 9.0
Dimensions (inches) 10.0 x 6.4 x 4.4 6.4 x 5.1 7.3 x 3.8
(H x W x D) (Dia. x D) (Dia. x D)
Table 2.
C. Unpacking.
After unpacking the Atkinson Dynamics Intercom, examine it for damage that
may have occurred in transit. If the equipment has been damaged, do not attempt to
install or operate it, and file a claim immediately with the carrier stating the extent of
the damage. Carefully check all envelopes, shipping labels and tags before removing or
destroying them.
Before attempting to install the intercom, be sure that all parts listed in the KIT
CONTENTS LIST have been supplied.
KIT CONTENTS LIST
Qty. Description Part Number
1 Resistor, 1 K, 1 W 101216
D. IntercomandModelADSV-25-ZMounting.
CAUTION
The selection of the mounting location for the device, its controls and the
routing of the wiring are to be accomplished by someone having a good under-
standing of automotive electrical procedures and systems.
The intercom is intended to be mounted on any relatively flat and rigid surface by
the two mounting ears on the exterior of the housing. Figure 9 is a dimensional outline
drawing showing the proper mounting configuration. The two mounting ears are 13/32"
diameter holes spaced 5.68" apart. Hardware for mounting the intercom to the surface
shall be provided by the installer.
WARNING
This unit is heavy and should be mounted on a rigid surface capable
of supporting the weight of the intercom.
ModelADSS-25-ZMounting:
Speaker Model ADSS-25-Z is equipped with a serrated swivel-mounting bracket with a
locking nut that allows the speaker to be adjusted through an angle of 90 degrees. Fig-
ure 11 is a dimensional outline drawing of the speaker. The speaker-mounting bracket
is intended to be mounted on any relatively flat and rigid surface. There are three
mounting holes present in the base of the mount. Hardware for mounting the speaker
shall be provided by the installer.
-4-
(15 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels